Sunday, August 9, 2015

TRIUMPH BONNEVILLE THRUXTON SCRAMBLER PLUG & PLAY FENDER MOUNT LAMP KIT

So you now own a gorgeous Triumph with a hideous tail light. Don't want to be seen on Main Street with that on board. Whatcha gonna do?
                                What can you do?
Well there are some kits available constructed from a piece of bent up plate that show all the wires hanging out the back of the lamp.  But ....No flexibility in tail lamp choice....No style..... No upgrade.
If you have the tools, time and skill you can always make something fit and drill some holes in the fender, fiddle around with the wires, blow a fuse or three and waste a weekend.
OR............................................................
You may consider a new low profile plug 'N' play tail lamp kit.
  Direct bolt on. No drilling. No fiddlin'
   1/  Housing interchangeable with different lamps and signals.
   2/ Easy swap out any tail lamp.
   3/ No visible wires hanging out back of lamp. All connectors concealed/weather proofed in housing
   4/ Compatible to European turn signal spacing law.
   5/ Compatible to Outlaw standards.
   6/ Kit fits direct to existing tail light harness with O.E.M connectors
   7/ Fits Bonneville fender or Bobbed Thruxton/Scrambler fender
   8/ All rear lamps have running / brake light and license plate illumination
   9/ Only 4 basic tools needed for install : 4mm Allen wrench, 10mm wrench, crimp pliers,
       17mm or adjustable wrench
                                                   
                              Housing is aluminum casting hand polished to perfection. 
              Fitting o.e.m base gasket and utilizing rubber mounting eliminating vibration.

LED lamp filament bulb signals
             
L.E.D REAR LAMP AND SIGNALS

LUCAS 525 LAMP/OEM SIGNALS
LUCAS 525 LAMP/BULLET SIGNALS




L.E.D CYCLOPS
MILLER TAIL LAMP
LED lamp filament bulb signals satin finish housing

PERFECT FOR EUROPEAN SIGNAL REQUIREMENTS
FITS THRUXTON/BONNEVILLE OR SCRAMBLER BASE GASKET
Fender Harness Diagram
When using kit with bullet signals and Lucas or Miller lamp. See below for the color hook up instruction. LED kits are supplied with  color hookup instructions as per lights in kit.

Harness wire color                Lamp wire Color
                         --Connects to--
Red  (running light)               Black
Blue  (brake)                         Red
Black  (ground)                     Black wire connected to housing
Orange                                  + Turn signal Left
Brown                                   + Turn signal Right
10mm wrench remove 3 nuts. Fender removal not necessary. Housing can be removed and connectors uncoupled  

Remove 3 screws securing housing to bracket

Unbolt signals and replace. If using stock signals skip this step
Replace Maund housing and lamp on bracket using stainless screws and spacer."Tip". Use grease on screws to prevent spacer slipping. 2/ Plug in connectors as necessary making sure seating gasket is in place. Tighten 3x 10mm nuts to secure to fender. Done


1 3/4 INCHES LOWER

LED lamp filament bulb signals

L.E.D CYCLOPS
MILLER TAIL LAMP

Here is a little trick way to slick your license plate with a stock fender set up. Might not be the best                            idea if you live in a state that's main revenue is writing traffic tickets.
With hacksaw or cutoff disc slice 7/8" either side of bracket. Can be bent fairly easy or gently formed with a hammer. I found a 2 1/2" radius worked.

Desert racer style (Thruxton/Scrambler fender). Reduced to width of fender and easily read. 

Clears long and short fenders




No comments:

Post a Comment