Friday, August 11, 2017

Fender Eliminator Triumph Bonneville T120, Street Twin, Street Scrambler, Bonneville T100

I've added a whole new section to maundspeed.com .....F.E.K's for T120 /T100 Bonneville, Street Twin and Street Scrambler.
    Its not eye wash!  Its all in stock and ships day of order.
                      Available in 3 finishes:
1/ Satin brushed aluminum. (to match engine cases)
2/ Military Spec. abrasion/impact resistant crinkle black
3/ Black
 Click to Enlarge!



Selection of rear lamps supplied with LED or filament bulbs.
Brackets available with or without turn signals.
Turn signals are fitted with filament bulbs and compatible with plug/play connections
Q/C harness is optional. All kits are equipped with stainless mud pan.  
Here are some pictures of fitted kits. Thanks to the help of my pals at Douglas Motorcycles.        There is a good reason, they are oldest remaining British motorcycle dealership in the Los Angeles area.


Miller LED









ASSEMBLY
 

1/ Disconnect connector plug for fender harness.
2/ Remove 4 fender bolts with T30 driver.
3/ Eliminate fender.
4/ Install tail lamp and signals to bracket. If fitting turn signals use the 2 spacers provided.
5/ Position stainless mudguard and loosely attach nuts to forward 2 bolts.
6/ Align lamp bracket, with the mudguard nesting inside bracket. Using 2x oem bolts, stainless washers and nyloc nuts supplied. Loosely attach.
7/ Remove rear screw from seat latch with T30 driver. Replace with stainless screw supplied, aligning with hole in lamp bracket. Then secure using 6mm nut and washer supplied. Snug up. Do not over tighten.
8/ Fully tighten 4 previously installed fasteners.
9/ Connect wires as below for filament bulb Lucas 525. Long black wire with ring terminal, on Q/C harness, connects to either threaded stud on back of lamp chassis. 
  Connecting LED lamps is explained below.

 Q/C Harness                 Connects to
ORANGE ...............................RED BRAKE LIGHT +
BROWN.................................BLACK TAIL LIGHT +
BLACK (W/RING TERMINAL) .....GROUND -
BLUE........................................R/H TURN +
RED.........................................L/H TURN +
BLACK DUAL CONNECTOR .........SIGNAL GROUND -

Turn Signals
BLACK.........POSITIVE +
BLACK/WHITE .......NEGATIVE -

LED Tail Lamp Connections

 LED Lucas 525  
YELLOW.............GROUND -
BLACK................TAIL LIGHT +
RED......................BRAKE +
  
LED Smoke 
BLACK.................GROUND -
RED.......................TAIL LIGHT +
GREEN..................BRAKE +
  
LED Miller Stop & Red Lens LED
BLACK..................GROUND -
BLUE.....................TAIL LIGHT +
RED.......................BRAKE +


 If hooking up to stock harness on Thruxton 1200, Bonneville or Street Twins this is what you need know.
BRAKE LIGHT + ............GREEN/PURPLE
TAIL LIGHT +.................YELLOW
R/H TURN +...................GREEN/WHITE
L/H TURN +...................GREEN/RED
GROUNDS-.....................BLACK



2 comments:

  1. Best design I have seen. Saving for one of these now. Should be ordering in a few weeks.

    ReplyDelete
    Replies
    1. Glad you like. Top quality equipment with attention to finish and fit.

      Delete